Planar C3013T Manual de usuario descargar pdf (Pagina 22)

Replacing the Fuses

Figure 13

Use only the fuses specified below to prevent damage to the Clean Screen.

Fuses: F1 Schurter 001.1014, 10 A

F2 Schurter 3402.0012, 2 A

F5 Bussman GDA-10A, 10 A

1. Remove the back housing as above.

2. Using a small (jeweler type) flat screwdriver, gently pry up on the fuse.

3. To remove an F2 fuse, gently pry the metal bracket at either end and then lift the fuse out.

4. Snap in a new fuse that meets the above specifications.

Technical Note: The F1 fuse used in earlier products has been replaced by the F5. Depending

on your product version, you will have either an F1 or an F5, but not both.

Chapter Three: Hardware Installation and Replacement 11

Fuse (F1) Schurter 001.1014, 10A; Fuse (F2) Schurter 3402.0012, 2A

or Fuse (F5) Bussman GDA-10A, 10A

CS Manual LAYOUT#1787 3/9/98 5:33 PM Page 11

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 59 60

Sin comentarios

Planar C3013T Manual de usuario Pagina 22